Linda's Yarn Bowl

Making this yarn bowl for Linda's Xmas present 2023. It will match our coffee table because it is made from cut-offs from it. And the slab/tree used for the table top was once in a fire long before it was cut down. Many challenges with it.

A yarn bowl for Linda

This is what they look like glued up. I used hanger iron and a small bolt but a large gear clamp would work too. I will be painting the oak(white) one. And yes it is a bad photo, they are both the same size.

A yarn bowl for Linda

I put these clamps on for a few minutes just until the glue starts to catch.

A yarn bowl for Linda

While the glue was drying, in the previous photo. I took and carved the top ring some and charred it black with a torch.

A yarn bowl for Linda

Turning the inside.

A yarn bowl for Linda

Cut out the spot to have the yarn feed through. One pig tail type and two holes.

A yarn bowl for Linda

Tried walnut stain on the oak. Big mistake, it's ok on the side. But on the quarter sawn base it is ugly, sanded most of it off.

A yarn bowl for Linda

It matches our coffee table.

A yarn bowl for Linda

I think Linda will be pleased. Merry Christmas!